American Flyer Track Terminal 690 Instructions

The track terminal was attached to the track, the accessory, and the transformer. When the train passed over the track terminal, the circuit was completed and the accessory operated as desired. The track terminal was manufactured from 1946 to 1956.

American Flyer Track Terminal 690 Hook Up Instructions

American Flyer transformers normally have three binding posts labeled BASE, Variable and fixed. The train is connected to the Base (common) and to the middle variable voltage post . Most accessories and lights are connected to the base and fixed voltage posts.

Step 1 – Connect the terminal clips to the underside of the track across both rails.
Step 2 – The two wires than connect to the end of the terminal.
Step 3 – Connect to the transformer.

American Flyer Track Terminal Production Variations

  • American Flyer Track Terminal 707

This is the service bulletin furnished by the A. C. Gilbert Co. to authorized service stations to aid them in the service and repair of American Flyer equipment. Specifically, this bulletin is for the American Flyer Track Terminal 690 Wiring

Instructions for Attaching 3/16 Scale Track Terminal No. 690 - Page 1

Instructions for Attaching 3/16 Scale Track Terminal No. 690 – Page 1

Recommended Books

Instructions for Attaching 3/16 Scale Track Terminal No. 690 - Page 2

Instructions for Attaching 3/16 Scale Track Terminal No. 690 – Page 2

Submit a Comment